Welcome to TP-LINK Tech Support Forum

Search:

Type: Posts; User: R1D2

Page 1 of 5 1 2 3 4

Search: Search took 0.04 seconds.

  1. Yes, I tried and it works fine. BTW, take a look...

    Yes, I tried and it works fine. BTW, take a look at the new SMB community for actual posts regarding Pharos devices: https://community.tp-link.com/en/business/
  2. Yes, that's right. In client mode the CPE just...

    Yes, that's right. In client mode the CPE just extends the camping WiFi network to the local network (the CPE's Ethernet port). Watch the network settings of your laptop: it should get a dynamic IP...
  3. Replies
    10
    Views
    11

    Did you save the config after applying changes?

    Did you save the config after applying changes?
  4. Replies
    3
    Views
    4

    No conflict. If ESSIDs are the same, you have...

    No conflict. If ESSIDs are the same, you have roaming between APs in effect. The clients then choose the AP which has the best signal quality and further use the AP's BSSID to stay connected. ESSID...
  5. Thread: Cpe210

    by R1D2
    Replies
    4
    Views
    5

    See this thread, it describes the firmware...

    See this thread, it describes the firmware recovery for a CPE: https://forum.tp-link.com/showthread.php?81684-How-to-use-firmware-recovery-function-of-Pharos-CPE

    If this doesn't help either, the...
  6. Replies
    11
    Views
    12

    This is b/c of half-duplex protocol nature of...

    This is b/c of half-duplex protocol nature of WiFi. Nothing to worry, throughput can be reached anyway.



    You could try to set distance to either "Auto" or the actual distance and set WiFi mode...
  7. Replies
    5
    Views
    6

    How did you come to PoE? I didn't write anything...

    How did you come to PoE? I didn't write anything related to PoE in this thread. I did mention PPPoE, which is something completely different.

    Anyway, I never ever claimed that PoE would require...
  8. Thread: Cpe210

    by R1D2
    Replies
    4
    Views
    5

    Try a factory reset, if that doesn't help, try a...

    Try a factory reset, if that doesn't help, try a firmware update.

    Are you using the CPE outdoor? If so, did you ground the device to protect it against atmospheric ESD?
  9. Replies
    21
    Views
    22

    Do you have proper grounding for your CPE? A...

    Do you have proper grounding for your CPE? A standard CAT.5e UTP cable does not provide proper grounding.



    It doesn't matter where you place the PoE injector as long as you have an AC power...
  10. Replies
    5
    Views
    6

    Because DynDNS is a work-around for public static...

    Because DynDNS is a work-around for public static IPs used on WAN routers and it makes no sense to run it on APs in a LAN. Arguing that "any device" (really? Your switches and printers, too?) can run...
  11. In my experience there are interferences (even if...

    In my experience there are interferences (even if set to different channels) if pointing in the same direction. I think, in different directions interferences are no big problem. Vegetation is more...
  12. Replies
    1
    Views
    2

    No, EAP 110 cannot be used in STA (client) mode....

    No, EAP 110 cannot be used in STA (client) mode. It's just an AP offering MASTER mode.
  13. Any port which is a member of more than one VLAN...

    Any port which is a member of more than one VLAN is a trunk port by definition. Note that the 802.1q standard does not use the terms "access port", "trunk port" or "general port". There are only...
  14. Replies
    3
    Views
    4

    Use EAP Controller to configure basic settings,...

    Use EAP Controller to configure basic settings, then override the SSID of each AP.

    For more infos about basic config see the User's Guide for the EAP Controller, available in the support section...
  15. Ah, finally the spam posts are gone. :)

    Ah, finally the spam posts are gone. :)
  16. TL-WA7210 is not a Pharos CPE, it uses another...

    TL-WA7210 is not a Pharos CPE, it uses another (older) firmware.



    No. Problem is not the TL-WA7210, but rather your client devices, which hardly can connect over a distance of 60m due to their...
  17. I have already reported to TP-Link with a...

    I have already reported to TP-Link with a reference to your screenshots in this thread, so let's see if they find out something.
  18. Yes, open a ticket. I will inform my support...

    Yes, open a ticket. I will inform my support contact, too.
  19. Products for different regions are often become...

    Products for different regions are often become available at different times. Maybe those CPE models will become available in the EU later this year - I hope so. :)
  20. Won't work since config storage on EAPs is...

    Won't work since config storage on EAPs is unknown to me. I have just changed channel width, channel limit and IEEE802.11 mode, rest is same as in factory settings.
  21. Most captive portals need Layer 2 transparency,...

    Most captive portals need Layer 2 transparency, thus it won't work with WISP mode (captive portal doesn't recognize the client's MAC address). Use the CPE in Client mode rather than in WISP (AP...
  22. IMHO that's a bug. You could open a ticket with...

    IMHO that's a bug. You could open a ticket with TP-Link support.



    I have configured Auto channel selection because static selection in 5 GHz isn't static at all due to DFS. However, in my...
  23. If I limit the frequency band, it selects...

    If I limit the frequency band, it selects channels 100 to 136:

    7706




    Do you use EAP Controller?

    If settings are not changed by EAP Controller and channel switch to U-NII-1 band happens...
  24. That's not a problem, but DFS (Dynamic Frequency...

    That's not a problem, but DFS (Dynamic Frequency Selection) and it is required by law to switch channels if other, higher priority use is detected by the CPE in order to not interfere with commercial...
  25. Replies
    3
    Views
    4

    That's right. Of course, if PowerLAN adapters of...

    That's right. Of course, if PowerLAN adapters of the same type are talking to each other, they use the speed both are capable of. Questions was wether faster ones (TL-PA7020P) can communicate with a...
Results 1 to 25 of 117
Page 1 of 5 1 2 3 4

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.