Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 4 of 4
  1. #1

    Load Balancer / TL-R470+ Configuration

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    I have a TP-Link load balancer and the Deco M5 System. Since the deco uses the 192.168.0.x subnet, I placed the load balancer on the 192.168.1.1 IP address, but often the deco system has no throughput even though the load balancer is working. So i tried to place the load balancer on the 192.168.0.x subnet. Here is worked perfectly BUT the DHCP went crazy giving some devices 192.168.0.x addresses and some other with 192.168.1.x addresses. How should we work with Deco M5 & a Load balance ????

  2. #2
    You can set the deco in AP mode. The load balance router will be the only DHCP server to give IP addresses. http://www.tp-link.com/us/faq-1842.html

  3. #3

    Unhappy

    Quote Originally Posted by Shield101 View Post
    You can set the deco in AP mode. The load balance router will be the only DHCP server to give IP addresses. http://www.tp-link.com/us/faq-1842.html
    Done that and the load balancer works for a while then no throughput. I also tried another load balancer (my old Cisco RV042) and had the same problems. Just now I have set the balancer into backup mode.

  4. #4
    How does the deco system connect to the load balancer? Can you share a network map? And is the deco running the latest frimware version, the build 20170820 one?


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.