Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Page 2 of 2 FirstFirst 1 2
Results 16 to 17 of 17
  1. #16
    A1: The slave Deco unit will not be router mode, if you didn't connect the slave deco to main deco by ethernet cable, it would be like extender, then if you connect an ethernet cable between them, the slave deco would be working with ethernet backhaul, no need to switch the mode manually;
    A2: Similar to the question 1, after you install all the 3 Deco normally, the main Deco is on router mode, the other two slave Deco are in extender or access point mode, when you switch the mode on the Deco App, it is changing the mode on the main Deco.

  2. #17
    Hi Enson Loo

    Many thanks for your help, it works fine now and I understand the difference.

    Cheers


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.