Model : NC220

Hardware Version :

Firmware Version : 1.1.14 Build 161219 Rel.28647

ISP : [/COLOR]

The camera is always on and doesn't respond to the schedule within "TP-Link Camera Control"

The camera control program on the PC can see an image through the camera
The schedule doesn't seem to make any difference. I have a tick in enabled
I am connected via wireless.

Firmware is
1.1.14 Build 161219 Rel.28647
This is later than is on the web site of
NC220_v1.1.12_160321_b

From http://www.tp-link.com.au/download/NC220.html#Firmware

Anyone have any suggestions?
Thanks