Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Junior Member den_localnet is on a distinguished road
    Join Date
    Apr 2017
    Posts
    1

    Exclamation TL-SG108E/105E V2 Loopback Detection dont work normaly

    Model : TL-SG108E

    Hardware Version :

    Firmware Version : TL-SG108E(UN)_V2_160526

    ISP : lan.ua[/COLOR]

    Standart "Recover Time" on this switches about 1 seconds. Recover Time can not be customized.
    Every second the switch turns on the port with the loop and the broadcast storm spreads through the network for another 1 second. So goes on in a circle.
    How to set a "Recover Time" of at least 300 seconds?

  2. #2
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,139
    I have no idea what you are observing and what in this respect should be "normal" or "recovery time", but if I enable Loop Detection on my TL-SG108E and create a loop, it blocks the port with the higher number and shows this blocking by blinking both (green and amber) LEDs every second or so. Only traffic on this port is the probe package of the switch needed to detect this loop, and yes, this will be sent about every second:

    Name:  Untitled.png
Views: 0
Size:  141.4 KB

    I can't see a "broadcast storm" either on my switch. Why would you want to extend this time to 300 seconds? This is no "recovery", this is just a probe package sent out by the switch. A real "recovery" would be to remove the loop ASAP after it has been detected and that's the only meaningful action to take in such case.


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.