TL-R600VPN Tunnel created but I need to from the other router

[kotusha]

Model :

Hardware Version :

Firmware Version :

ISP : [/COLOR]

Hi,

I have router A and B both are TL-R600VPN, I created the tunnel and it work fine, but I need all the Internet traffic of router B to get out from the internet of router A, does anyone know how to do that.

Thank you

Rafael Olivas

TL-R600VPN

[Carat1]

Write a static route on Router B in order for all the data to go out of the next hop are pointing to the gateway of router A. Maybe this works.

[atupal]

I have the same problem and the static route of Router B cannot be set as follows:

Destination Network: 0.0.0.0
Subnet Mask: 0.0.0.0
Default Gateway: Local IP of Router A

It show the follow message if I input the destination network as 0.0.0.0

Error code: 4001

Bad destination IP address, please input another one.

[Panda]

Yes, I have tried this before. This can't be supported by the R600VPN. The only way is set a PPTP Client to LAN VPN.

[kotusha]

This is a good improvement to add in to the firmware.