Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 5 of 5
  1. #1

    TL-R600VPN Tunnel created but I need to from the other router

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hi,

    I have router A and B both are TL-R600VPN, I created the tunnel and it work fine, but I need all the Internet traffic of router B to get out from the internet of router A, does anyone know how to do that.

    Thank you

    Rafael Olivas

    TL-R600VPN


  2. #2
    Write a static route on Router B in order for all the data to go out of the next hop are pointing to the gateway of router A. Maybe this works.

  3. #3
    Junior Member
    Join Date
    Apr 2017
    Posts
    1
    I have the same problem and the static route of Router B cannot be set as follows:

    Destination Network: 0.0.0.0
    Subnet Mask: 0.0.0.0
    Default Gateway: Local IP of Router A

    It show the follow message if I input the destination network as 0.0.0.0

    Error code: 4001
    Bad destination IP address, please input another one.

  4. #4
    Yes, I have tried this before. This can't be supported by the R600VPN. The only way is set a PPTP Client to LAN VPN.

  5. #5

    improvement

    This is a good improvement to add in to the firmware.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.