Trunk T1600G-28PS to SG3424 with Vlans
Hardware Version :
Firmware Version :
ISP : [/COLOR]
I set up LAG between the two Switches. LACP ist ok, LAG is up. Although the LAG Ports are tagged I cant access to all connected devices on the T1600G-28PS.
It seems to be that the Vlans are not routed to the T1600.
Between my SG3424 and my other witch SG3216 all is ok.
I found out, that I cant change the link type on T1600. On my other switches I can. I read somewhere that on T1600 the ports are link type "GENERAL" if you set up LAG. How can I Change the link type on the T1600? I have to change it to TRUNK
This is not only important for Lag's. If I want to connect two switches with only one cable I also have to hange the link type.
I hope I explained my problem right...;-)
Or am I wrong? Is there another way for that switch?
same problem here.
Same problem here with a T1600G-52TS.
We try to setup 3xVLANs
And when we plug the gateway on port 42 (and all others on VLAN1), we can't acces from other VLAN (100 & 200).
- VLAN 100 - 1 to 20
- VLAN 200 - 21 to 40
- and the rest on VLAN 1 - 41 to 52 (normaly as TRUNK)
I our configuration, we can acces (ping) :
But when we plug the gateway (and other device like DHCP) on VLAN 1, we can't access from VLANID100 et 200...
- from VLAN 100 to VLAN 1 (and reverse)
- from VLAN 200 to VLAN 1 (and reverse)
- not between VLAN 200 and VLAN 100 (as we want the configuration)
We have read a lot of tutorials. And see TRUNK status on link status. And in our manager interfaces, we dont see anything like that... Ports is ONLY on "general".
Maybe somebody can help with us ?
PS : Last Firmware was set on device.
Thx a lot,