Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    Loss of Secure Powerline Network Configuration

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Products: TL-PA4010PKIT(UK) ver 2.1
    Firmware: 1.1.0.844-01-20120919-FINAL

    I have four adapters configured to as a network group, using my network name and not the default "HomePlugAV".

    For most of the time this works well. However, I have noticed that at times I lose access to parts of the network, typically manifesting as one of:
    - No Internet access
    - Printer not online

    Investigations using the Powerline Utility that shipped with the products, indicate that one or more of the adaptors has lost it's connection to one or more of the other adaptors. To resolve this issue using the Powerline Utility it was necessary to physically connect to each adaptor and to set a new network group name. A simple power off/on of each adaptor does not clear the problem, hence I suspect the root cause is some form of memory corruption (buffer/counter overrun?).

  2. #2
    This post is an update to my previous posting.

    Product Model: TL-PA4010P KIT(UK)
    Hardware Version: ver 2.1

    Firmware: 1.3.0.2134-00_401192_160311_906

    Since the firmware update the network works well. However, every 2~3 months connectivity is lost - typically being noticed by either the Xbox One not being able to connect to the Internet or iPads being unable to locate an Airprint printer.

    Using Powerline adaptors in a secure network configuration (using my private network name), both devices/network segments are star-connected to my ISP router:

    . . . . . . . . . . . . . . . . . |+PA2---Xbox
    .Internet--RTR--PA1+|+PA3---Ptr & Office LAN
    . . . . . . . . . | . . . . . . . |+PA4---'Hotdesk'
    . . . . . . . . WiFi

    An investigation using the tpPLC confirms that PA1 has dropped out of the secure network and does not see any other members of that network. The other three PA's, who typically (but not always) remain members of the same secure network and thus whilst they no longer see PA1 they do continue to see each other.

    To restore service, I have found it is necessary to use tpPLC on PA1 and save my network name to the adaptor. Having re-established my secure network, I then save the secure network name to all adaptors in my network; this seems to avoid the other adaptors from dropping out, of which PA2 is typically the one to follow PA1.
    Following my fix, I have tried swapping adaptors over and have confirmed the first to fail will be whichever adaptor is installed as PA1, followed by PA2.

    I therefore conclude this specific product model has a memory leak/buffer overrun or similar fault that causes the NVR holding secure network configuration data to be corrupted - as a simple power off/on doesn't enable the network to be re-established. However, in saying that I note that tpPLC gives no indication that user supplied configuration data (eg. device name, traffic priority etc.) has been corrupted.

    Not sure of the solution to this as the latest firmware on the TP-Link(UK) website: TL-PA4010P(UK)_V2_160316 published 2016-03-16 installs the version I am currently running.
    lFrom some of the other comments it would seem the ony solution will be to replace with products from other vendors...
    Last edited by Roland61; 01-09-2018 at 22:37.


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.