Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    EAP Controller LED Settings

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hi there,

    i just have a "nice to have" Wish. Can you please add a LED Setting feature in the EAP Controller software , so i can switch the LED to on or off for specific APs?
    We have some AP locations where the LED light is a little bit too bright. So we want to switch it off. On other APs in the same Site it should be on.

    Is this possible?

    thank you
    1x TL-SG3424P v2.0
    3x EAP225

  2. #2
    I do think it would be good to configure this on a per-AP basis, but in the meantime are you aware of the system-wide LED setting? If you go Settings > System > LED you can turn off the LEDs for all APs.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.