Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    EAP Controller LED Settings

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hi there,

    i just have a "nice to have" Wish. Can you please add a LED Setting feature in the EAP Controller software , so i can switch the LED to on or off for specific APs?
    We have some AP locations where the LED light is a little bit too bright. So we want to switch it off. On other APs in the same Site it should be on.

    Is this possible?

    thank you
    Best
    Ronald
    1x TL-SG3424P v2.0
    3x EAP225

  2. #2
    I do think it would be good to configure this on a per-AP basis, but in the meantime are you aware of the system-wide LED setting? If you go Settings > System > LED you can turn off the LEDs for all APs.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.