AP and Vlans
Hardware Version :
Firmware Version :
ISP : [/COLOR]
i need following informations. How do i get my Eap110 work with a two vlan constellation? I can set it up when the uplink is a Accesport and then change to trunk, and it seem to work, but the accesspoint goes offline.i dont really know what to do
Your laptop/upstream router/whatever must handle the VLANs and assign it to two subnets. See this post for an example how this can be done:
I have a Cisco Switch, i can configure the APs when they are in the same VLAN as the controler PC and then switch to a dot1q Trunk link and it is working wih the vlan / SSID seperation. But After 30 seconds the APs swich to the disconnected state on the controller (they are still working). Can anyone help?