Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 10 of 10

Thread: AP and Vlans

  1. #1

    AP and Vlans

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hi ,
    i need following informations. How do i get my Eap110 work with a two vlan constellation? I can set it up when the uplink is a Accesport and then change to trunk, and it seem to work, but the accesspoint goes offline.i dont really know what to do

  2. #2
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,139
    Your laptop/upstream router/whatever must handle the VLANs and assign it to two subnets. See this post for an example how this can be done:
    http://forum.tp-link.com/showthread....l=1#post189570

  3. #3
    I have a Cisco Switch, i can configure the APs when they are in the same VLAN as the controler PC and then switch to a dot1q Trunk link and it is working wih the vlan / SSID seperation. But After 30 seconds the APs swich to the disconnected state on the controller (they are still working). Can anyone help?

  4. #4
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,139
    Quote Originally Posted by goliard View Post
    Can anyone help?
    See http://www.tp-link.de/faq-1365.html

  5. #5
    When its one Vlan per AP why different SSIDs?

  6. #6
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,139
    Don't understand the question. When it's one SSID per AP, why would you want to use VLANs then? If you have one SSID per AP to connect to VLANs of your network, terminate the trunk at the switch an use untagged ports which are member of the corresponding VLAN to connect the APs to.
    Last edited by R1D2; 04-12-2017 at 00:31.

  7. #7
    Cause its possible to generate multiple ssids on the devises and magically they work with vlans but the management tool doesnt see the APs anymore.

  8. #8
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,139
    Quote Originally Posted by goliard View Post
    Cause its possible to generate multiple ssids on the devises and magically they work with vlans but the management tool doesnt see the APs anymore.
    See http://www.tp-link.de/faq-1365.html for using the EAP controller with APs in different VLANs.

  9. #9
    wanne have vlan 100 and 200 on the same AP

  10. #10
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,139
    Just read the documentation. It's all in there.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.