Trouble Using Bulb Manually (Only Blinks Twice)
Model : TP-Link Smart LED Light Bulb, Wi-Fi, Dimmable, A19, Tunable White, 60W Equivalent, Works with Amazon Alexa, 1-Pack (LB120)
Hardware Version : ?? Not sure where to find this on the bulb
Firmware Version : ?? Not sure where to find this on the bulb
ISP : [/COLOR]
When I first got the bulb, I was easily able to configure it for use with Alexa.
My wife however, prefers to use it manually so I took it off the network and even re-installed the Kasa app
Now when turned on via a switch on the lamp, it lights up but after ten seconds blinks twice BRIGHTLY then reverts to the previous state
I tried re-configuring it to the network but I'm not able, even in manual mode. In this process I erased the bulb's preset as directed.
I have another TP-Link that works flawlessly in any application, networked or not.
Last edited by kbecka; 01-26-2017 at 00:58.
but it's combined with another issue. Yesterday this particular bulb worked just fine. This morning Alexa told me it was offline. I used the Kasa app and it worked fine except that it said local wife only. Then that note disappeared but Alexa still couldn't control it though it could rediscover it when I asked it to do so. So then I had Alexa "forget" it and I went into the Kasa app and disconnected it too. But then I had trouble getting it reconnected. And for some reason it would only blink twice instead of three times. It did finally connect when I held my phone right next to the bulb. Finally I had Alexa rediscover it, which it did and Low and Behold! Alexa can now control it again. sigh. but I still love my smart system. I see that other people with other brand devices have the same problems. Guess it's just part of the wi-fi world.