Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 6 of 6
  1. #1

    Angry TL-PA9025P KIT V1 Utility


    Why is there no utility on TL-PA9025P KIT V1 web page ?
    Which software to use ?

    I tried to use tpPLC_Utility from TL-PA9020P KIT V1 but it doesn't work (impossible to change network name or device names).

    Thanks for your support.

    Last edited by LGO; 12-17-2016 at 18:43.

  2. #2
    Up .... If someone can help ?

  3. #3
    Junior Member Addikt is on a distinguished road
    Join Date
    Oct 2017
    Up !

  4. #4
    Download the latest from the 9020 support web page

  5. #5

    That's not helping.
    There are no firmware update for this device available on TP link web.

  6. #6

    You asked about the management utility (tpPLC). The version for the 9020 will give you the latest - which should work on all current adaptors.

    If that doesn't work then try a factory defaults reset (hold down the sync button and repower the adaptor - and hold the button down for 15 seconds)

    If your current firmware version is less than 3.2.4b then you probably need to contact TP-Link support to get them to provide (or ideally upload to the support site) a current version...Earlier versions are very buggy and have disconnect / performance issues.

    Last edited by The Vogon; 10-06-2017 at 16:44.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.