Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 7 of 7
  1. #1

    HS200 and 3-way light switch

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    I would like to install my new HS200 Smart WiFi Light Switch in my office where I currently have a 3-way light switch installed. The existing light switch has 2 black wires connected to one side and 1 red wire connected to the other side. The instructions that I've been able to find so far do not seem to accommodate this light switch setup. Does anyone know if I am able to use my HS200 to replace my existing light switch and if so how I should do that? I would prefer not to use trial and error to see if I can figure this out. :-)

  2. #2
    HS200 is not compatible with 3-way switches.

  3. #3
    Junior Member stuntmonkeys is on a distinguished road
    Join Date
    Dec 2016
    Posts
    1
    Is there a white neutral wire in the box where you want the HS200? If so, do you know where the other 3-way light switch is? If so, you can disconnect the red wire at both ends (one end in the box where you want the HS200 and the other end in the other 3-way switch) by capping and taping them. By doing this, you are abandoning the red wire in place. Then install the HS200 by attaching the two black wires and the white neutral as described in your instructions. Your HS200 will only work when the other 3-way switch is in the "on" position. Turning that switch off will either (1) kill power to your HS200 (if the HS200 is downstream of the 3-way switch), or (2) kill power to your light -- but not the HS200 (if the HS200 is upstream from the 3-way switch).

  4. #4
    Junior Member MarceloGuerra is on a distinguished road
    Join Date
    Mar 2017
    Posts
    1
    Found this and tested.

    REALLY WORKS!!! PERFECT!!

    http://www.instructables.com/id/TP-L...ay-Capability/

  5. #5
    Thank you so much for sharing this! Just ordered the parts and I'm pumped to try it.

  6. #6
    Quote Originally Posted by MarceloGuerra View Post
    Found this and tested.

    REALLY WORKS!!! PERFECT!!

    http://www.instructables.com/id/TP-L...ay-Capability/
    Just put mine together but I am stuck on step 5. Where do I attach the blue and white cables to the control board? The picture is not clear! Any help is much appreciated!

  7. #7
    There are easier and probably safer ways... and ways that are more likely to comply with the electrical code: https://sites.google.com/site/mppsui...ofaq/wemo3ways (originally for WeMo but works with TP Link as well).


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.