1. Install the Tftpd32 /Tftpd64
on your computer based on the system type(32bit/64bit), here we take Tftpd32 as an example ;
Download link: http://tftpd32.jounin.net/tftpd32_download.html
2. Download the proper firmware of Pharos CPE products, here we take firmware pharos_un-up-ver1-0-0-P25-[20140709-rel51929].bin
of CPE510 as an example, then must
rename the firmware as recovery.bin
3. Configure IPv4 address of your computer as 192.168.0.100/255.255.255.0
, you can click Here
to configure static IP for the computer.
Firmware Recovery Procedure
Connect your computer to the LAN port of CPE510 with an Ethernet cable and run the Tftpd32.exe
, then navigate the Current Directory
to the folder where recovery.bin
Power Pharos device off first. Press the reset button
on CPE510 and then power it on. Hold the reset button for about 6-8 seconds and focus on Tftpd32.exe
interface at the same time. When you see the file transfer progress bar
appears as below, then you can release the reset button.
CPE510 will reboot automatically after the file transmission completed, please wait for a while until all the lights on CPE510 are flashing and then perform normally.
After reboot you may follow this link
to login the management page of CPE510 again.
Please only perform firmware recovery through wired
2. Tftpd32 exe/Tftpd64 exe
should be compatible with the Operating System, Tftpd32 exe should work with 32-bit System and Tftpd64.exe should work with 64-bit System.