Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2

Thread: WR720 bridge

  1. #1

    Question WR720 bridge

    Region : Canada

    Model : TL-WR740N

    Hardware Version : V4

    Firmware Version :

    ISP :

    I have internet with bell, all setup in 2wire modem( are all right, like DHCP set to - 50, wired,wireless both work good.
    what I want Tplink to do is connect to the network, use same ip range, like 192.168.2.x.
    The default tp-link ip is, it connect to, works fine now as a router.

    How to setup Tp-link WR720 to join in existing network, like a extend wireless, so I could move it to far end of my house.


  2. #2
    You may give a try on WDS settings on the TL- WR720N.
    Here is the instruction: http://www.tp-link.com/en/article/?faqid=227


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.