Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    Exclamation Deco M5 unit dead overnight

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Dear Support-Team,

    this morning I realized that my master Deco M5 unit obviously died overnight. All slave units are showing a red blinking light whereas the LED of the master unit is not lit at all. I tried to power cycle the unit with no success. No life comes into the unit. I have also checked it's power supply on another working unit and the power supply is fine.

    Any suggestions?
    Is the unit dead? Is there any reset procedure that I might try?


  2. #2
    There is a reset hole underneath the deco, you can simply press it once to reset it. But I don't think that would make a difference. Did you have power outage? If the unit just died for no reason, you can contact the shop to replace it or contact tplink support.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.