Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 3 of 3
  1. #1
    Junior Member Pupintor is on a distinguished road
    Join Date
    Mar 2018
    Posts
    1

    4G internet with TL-MR6400 router is very flaky, often stops working

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    I've set up 4G internet with the TL-MR6400 router, and it's very flaky, it intermittently stops working every couple of minutes. The intervals when it happens seems to be random, usually it works for 1-5 minutes, and then stops working for a minute or two.
    When it doesn't work, it's not like its speed decreases, but it stops working completely, and I get either a timeout, or a "DNS probe failed, no internet" error if I try to open something in the browser.

    Even when it doesn't work, I can still access the router management site, and the status page always says that the 3G/4G Connection Status is Connected, and the Signal Strength is always either 75% or 100%.

    In those minutes when it works, the speed and the throughput is always very good, for example I've just measured 16ms ping, 40Mbps download and 10Mbps upload. And then when it stops for a minute, it doesn't work at all.

    I tried both with the Wi-Fi, or with the Wi-Fi disabled and connecting with an UTP cable.

    I've checked the System Log a number of times, but I can only see DHCP messages, and sometimes this message: "IPv6; INFO; prefix is NULL, can't start radvd and npd6"

    I've installed the latest firmware. (I've seen before a similar issue with another TP-Link router caused by Killer Wi-Fi devices, but I see in the firmware change log that it was fixed some time ago, plus disabling the Wi-Fi doesn't seem to help.)

    I suspect this has to do something with the router, because if I take the SIM out and put it in a phone and use the internet from the phone, or use the phone as a Wi-Fi hotspot, then it works properly.

    Do you have any suggestions what should I try or how I could troubleshoot?

  2. #2
    If you have any Killer Wi-Fi devices, you need to disconnect them from Wi-Fi. Try with only one device connected to the tplink. Basically it points to the router. Contact tplink support to fix it.

  3. #3
    Did you try to reset the TL-MR6400 to see if the problem resloved?


 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.