Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 3 of 3
  1. #1
    Junior Member polps is on a distinguished road
    Join Date
    Jan 2018
    Posts
    1

    How to change DNS in Archer mr200

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hi all, I'm new in this forum.

    I'm using the MR200 router whit a SIM card.

    In order to improve the parental control settings, I would like to use the OpenDNS addresses instead the default ones.

    How can I change the default DNS addres and set the OpenDNS addres?

    Thanks in advanced.

  2. #2
    Junior Member Reinhard is on a distinguished road
    Join Date
    Feb 2018
    Posts
    2
    Check out section 11. 4. 2. Use the 4G LTE Router as a DHCP Server is the manual. Under Go to Advanced > Network > LAN Settings, you can specify your primary and secondary DNS server.

  3. #3
    Junior Member FiringSquad is on a distinguished road
    Join Date
    Feb 2018
    Posts
    1
    I have the same request.
    I changed the Primary and Secondary DNS Server, saved and rebooted, but the status page still shows the original DNS IPs.
    When I go in to the settings again, my OpenDNS IPs are still there.

    Looking at similar routers, they normally have a checkbox to activate this DNS, but there's no such checkbox visible.
    How can I get the OpenDNS settings to activate?


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.