Model : Archer MR200

Hardware Version :

Firmware Version : 1.2.0 0.9.1 v004a.0 Build 170927 Rel.58861n

ISP : vodafone[/COLOR]

Does not recognize LAN after being disconnected/connected from power line.

I need to do it with a device wich disconnects the router from power line an reconnects it again, in order to force the router to connect internet via 3G in a rural area when signal is ussually lost.

The router manages agricultural applications and ip cameras.

Till I unplug/plug the ethernet cable it does not detect the cable. Normally, is far enough the router to do it, so I lose connection with the applications.

This question worked fine with very lod routers !

Any suggestions?