Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    Resetting the Deco

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hi everybodyBeen some very frustrating hours with the new Deco system. See a lot of questions on this forum that several people have similar experiences.My first qeustion on this forum:When I reset a Deco unit by pressing a sharp object in the little hole, should the power to the unit be on or off? Or doesn’t it matter? How long should I press this button? The very minimalistic user interface with the single LED is frustrating, and as a user I am nearly always unsure what state each unit is in. It takes a lot of trial and error to walk through each new installation cycle of all three Decos.

  2. #2
    Deco must be powered on all the time during a reset.

    Tap the RESET button in the little for one second only, then the LED light on the node will become yellow, indicating that it's been reset.
    Just wait for about 2 minutes until the LED is pulsing blue, a reset has been done.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright © 1996-2018 TP-LINK Technologies Co., Ltd. All rights reserved.