Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Junior Member Jacethesparky is on a distinguished road
    Join Date
    Oct 2017
    Posts
    1

    Post Using a cpe510 and eap110

    Model : CPE510

    Hardware Version : Not Clear

    Firmware Version :

    ISP : [/COLOR]

    I am wanting to set-up a point to point 5Ghz link with the cpe510 between 2 buildings. My main question is, once i have configured this setup can i add an eap110 to use the 2.4ghz range as a wireless access point on the building i am sending signal. was told this can be done as by using the point to point in 5ghz it does not get interference from the 2.4Ghz range.

  2. #2
    Members R1D2 is on a distinguished road
    Join Date
    Dec 2015
    Posts
    1,009
    Sure, you can do it this way. See recent forum threads here describing such scenarios in greater detail.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.