Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    Deco is changing the LAN IP address

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    I have two PC's on my LAN that backup one another's files. I use Unison for this and it requires the LAN IP address of the other PC. After a failure this morning where the Deco blinked red, the LAN IP addresses changed. This also effects my firewall that also allows access from a specific LAN IP address. Is there a way to make the IP address permanent? I do not have this problem with my other routers. This is the first time I have had my Deco blink red in the two weeks I have had it but will be a pain if this occurs with every problem.

  2. #2
    This may be my error. At the time I set this lan up I had these two pc's both wired and wireless. I have them Ethernet connected to satellite Deco's. I may have used the wireless lan ip address for my backups and then disabled wireless on my pc's two days ago. This thread can be closed. If it happens again I will repost.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.