Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 5 of 5
  1. #1

    TP-Link NC250 Cloud camera

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Hello,

    I purchased 3 units of NC250 tomy home. them are workin fine.

    4th camera was purchased for my office room. I cannot configure it . This one works good in my home, so the camera is good.
    I attached 3 photos from my smartphone. I cannot continue over the steps that appear in the photos.

    Awaiting for a good help,
    roni
    Attached Images      

  2. #2
    By default, the password is also admin, so did you create a new one? or you can also try to factory reset it: with it powered on, press and hold the reset for about 10s

  3. #3

    i tried 5 seconds not 10 sec.

    i tried 5 seconds not 10 sec.

  4. #4
    Do you see the system led turns off when you reset it? only so, that means the reset is successful, so you may try again: with the camera powered on, press and hold the WPS/RESET button for more than 5seconds until the System LED turns off. Then release the button and wait the camera toreset to its factory default settings.

  5. #5
    my camera no cloud camera modem tplink 8410 :'( camera ip hikvision


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright © 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.