Welcome to TP-LINK Tech Support Forum
+ Reply to Thread
Results 1 to 3 of 3
  1. #1

    TL-WPA7510 LAN passthrough configuration

    Model :

    Hardware Version :

    Firmware Version :

    ISP : [/COLOR]

    Product: TL-WPA7510 KIT V1
    Original firmware only available.

    I purchased a TL-WPA7510 kit yesterday and have been having trouble configuring it. The WiFi side of the configuration is well covered in the manual and videos, however the LAN passthrough is not. I have configured the main device to accept an address via DHCP, which it has done, though I am not able to connect to the network on the machine connected to the Ethernet port on the remote unit. I'm getting the APIPA address (169.254.x.x; 255.255.0.0) on the remote connected machine. When I set the address manually I'm not able to connect to the rest of the network. Can anyone help me out with what I'm missing in the configuration here.
    Thanks

  2. #2
    Do both powerline LEDs light up? If no, need to pair them. If yes, connect a pc to your router to test the internet. Replug the powerline. It should work if your router is working, no need to set IP address manually.

  3. #3
    Thanks for getting back to me. I have since found the problem, it was the NIC drivers/BIOS version. Updated them both and the cable is working. I have now discovered the extender is not relaying WiFi according to my WiFi meter. I'll create another thread for that problem.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.