Welcome to TP-LINK Tech Support Forum
  1. Announcement:
    TP-LINK Forum Rules
    tplink ‎(Administrator)
    09-09-2012
    Views:
    27,526
+ Post New Thread
Page 3 of 4 FirstFirst 1 2 3 4 LastLast
Threads 47 to 69 of 73

Forum: Easy Smart Switches

  1. SG108E V2 No internet?

    Model : Hardware Version : Firmware Version : ISP : Just set up my SG108E V2 and am unable to connect to the internet. My pc reports the following problem: "Local Are Connection" doesn't have a valid IP connection. I updated to firmware : TL-SG108E(UN)_V2_160526

    Started by Dan Singer‎, 01-08-2017 23:46
    • Replies: 4
    • Views: 5
    01-15-2017, 13:15 Go to last post
  2. Question How to setup LAG between a couple of TL-SG108E switches

    Model : Hardware Version : Firmware Version : ISP : Hello,

    Started by dnax‎, 01-05-2017 14:45
    • Replies: 3
    • Views: 4
    01-06-2017, 22:42 Go to last post
  3. QOS by Ports logic: incoming vs. outgoing priorities ??

    Model : Hardware Version : Firmware Version : ISP : I am using "Port Based QOS" to enforce frame priorities consistently without relying on all packets being pre-tagged properly for 802.1P or DSCP.

    Started by glasser‎, 01-02-2017 22:35
    qos by ports
    • Replies: 1
    • Views: 2
    01-03-2017, 11:35 Go to last post
  4. TL-SG108E arp flood problem

    Model : TL-SG108E Hardware Version : TL-SG108E 2.0 (also had the problem on hardware version 1.0, the switch was swapped at the store since the issue could not be found) Firmware Version : 1.0.1 Build 20160108 Rel. 57851 (also tested multiple firmware releases on the hardware 1.0) ISP : ...

    Started by tomw‎, 12-15-2016 22:28
    • Replies: 7
    • Views: 8
    01-03-2017, 09:50 Go to last post
  5. Exclamation TL-SG108E, Stability problems due to heavy traffic

    Model : Hardware Version : Firmware Version : ISP : Hello,

    Started by Benny‎, 10-28-2016 11:07
    stability, tl-sg108e, traffic, vlan, wan connection
    • Replies: 3
    • Views: 4
    01-02-2017, 22:02 Go to last post
  6. SG108E VLAN Config Help

    Model : Hardware Version : Firmware Version : ISP : I have a Unifi USG in front of a few SG108E 8 port switches. 802.11q is enabled but I'm having a difficult time accomplishing what I am looking to do, which is to have a separate guest LAN. My main untagged LAN is 192.168.1.1/24, I...

    Started by bohemus‎, 12-29-2016 16:48
    sg108e, vlan
    • Replies: 2
    • Views: 3
    12-30-2016, 19:51 Go to last post
  7. Connecting TL-Sg105E to TL-ER604W stalls network

    Model : Hardware Version : Firmware Version : ISP : I'm trying to expand my network so I bought a switch to attach to my router. I did not unplug anything, I simply put the WAN/LAN switch in LAN mode, hooked up a CAT^ cable between it and my new switch, and voila, it did not work....

    Started by Roving3‎, 12-24-2016 07:21
    • Replies: 3
    • Views: 4
    12-30-2016, 19:11 Go to last post
  8. TP-Link TL-SG108E and Archer D9 not playing together

    Model : Hardware Version : Firmware Version : ISP : Ok. I have been using an Archer D9 for a wired and wireless home network and has worked fine until I need more ports. I have a media server that I have connected through Ethernet to the D9 and am accessing on multiple TV's via the...

    Started by desmondo76‎, 12-10-2016 07:06
    • Replies: 1
    • Views: 2
    12-30-2016, 01:59 Go to last post
  9. Lightbulb TL-SG108E Feature Request: Add descriptions to ports

    Model : Hardware Version : Firmware Version : ISP : Hello all, I've just received my TL-SG108E switch and it looks like a solid build. The management interface is simple, but allows you to do basic management on it.

    Started by mad_ady‎, 10-12-2016 09:03
    feature request, tl-sg108e
    • Replies: 4
    • Views: 5
    12-29-2016, 16:10 Go to last post
  10. TL-SG105e and Starhub IPTV (Singapore) issue

    Model : Hardware Version : Firmware Version : ISP : Hi,

    Started by elaurs‎, 12-22-2016 09:51
    • Replies: 2
    • Views: 3
    12-25-2016, 04:22 Go to last post
  11. Question Storm Control - What is a UL-Frame

    Model : Hardware Version : Firmware Version : ISP : Hello, I'm just reading up on the features included in the EasySmart series of switches and struggling to understand what a UL-Frame is. Storm-Control's User Guide Chapter mentions "Select to filter broadcast/multicast/UL frame...

    Started by 80211WiGuy‎, 12-19-2016 18:57
    storm-control, ul-frame
    • Replies: 1
    • Views: 2
    12-24-2016, 01:15 Go to last post
  12. TL-SG105E V2 and firmware versions

    I have a TL-SG105 2.0 with firmware version 1.0.0 Build 20151204 Rel.42055. Checking the greek or english tp-link site there isn't any new firmware but at the german and spanish site there is a new one ( TL-SG105E(UN)_V2_160526). Is it safe to upgrade my switch using the german/spanish firmware?

    Started by chrispe‎, 12-12-2016 10:29
    • Replies: 3
    • Views: 4
    12-16-2016, 12:14 Go to last post
  13. Web-based user interface on TL-SG105E is not there

    Model : TL-SG105E Hardware Version : TL-SG105E 2.0 Firmware Version : 1.0.0 Build 20151204 Rel.42055 ISP : Hello ,

    Started by mjtir‎, 12-10-2016 13:20
    • Replies: 2
    • Views: 3
    12-12-2016, 05:50 Go to last post
  14. TL-SG105E cable used with TL-WA901ND

    Model : Hardware Version : Firmware Version : ISP : I have a TL-WA901ND connected to my router working fine. Now I have installed a TL-SG105E between router and TL-WA901ND to connect other devices to the switch but it is not working, I do not get a Green led at the port where I...

    Started by fsbp70‎, 12-06-2016 09:48
    crossed cable, tl-sg105e, tl-wa901nd
    • Replies: 1
    • Views: 2
    12-08-2016, 05:39 Go to last post
  15. TP-Link TL-SG108E only the Power LED, Status and Link off

    Model : Hardware Version : Firmware Version : ISP : Hello, I bought a new TL-SG108E. The power LED is on. The status LEDs on the ports remain off even though there is a connection. I come to the network. Reset I have carried out. The tool does not find the switch. What am I doing...

    Started by camel288‎, 11-11-2016 14:40
    • Replies: 1
    • Views: 2
    11-29-2016, 05:17 Go to last post
  16. Question Return amazon TL-SG1008D switch directly to TP-Link?

    Model : Hardware Version : Firmware Version : ISP : Hey everyone.

    Started by josch.nrw‎, 11-11-2016 18:17
    • Replies: 1
    • Views: 2
    11-29-2016, 05:15 Go to last post
  17. TP-Link TL-SG108E only the Power LED, Status and Link off

    Model : Hardware Version : Firmware Version : ISP : Hello, I bought a new TP, but only the Power LED is on. The Status and Link LEDs remain off even in connecting. However, there is a connection to the network. Is that normal? It is also not possible to connect with the tool. The...

    Started by camel288‎, 11-11-2016 13:53
    • Replies: 1
    • Views: 2
    11-29-2016, 05:08 Go to last post
  18. SG108E Port Trunk specifications

    Model : Hardware Version : Firmware Version : ISP : Is there any documentation on using the Port Trunking feature in the switch? Has anyone had success? Simple google searches and looking at the user manuals only provide a vague description of the feature but don't include any...

    Started by craigels39‎, 08-30-2016 00:27
    • Replies: 5
    • Views: 6
    11-28-2016, 07:36 Go to last post
  19. Arrow Sending in a Device that has been bought on amazon

    Model : Hardware Version : Firmware Version : ISP : Hey everyone.

    Started by josch.nrw‎, 11-11-2016 16:19
    return defect amazon
    • Replies: 3
    • Views: 4
    11-17-2016, 02:01 Go to last post
  20. Question TL-SG1016DE security of changes value without any authentication.

    Model : Hardware Version : Firmware Version : ISP : Hardware Version TL-SG1016DE 2.0 Firmware Version 1.0.1 Build 20151218 Rel.58739

    Started by lexxai‎, 10-07-2016 17:46
    authentication, gui, security
    • Replies: 2
    • Views: 3
    11-13-2016, 01:27 Go to last post
  21. Trunk settings for dual switches.

    Model : Hardware Version : Firmware Version : ISP : I am trying to connect 2 switches together without much success using trunking.

    Started by avayredtech‎, 09-30-2016 14:48
    • Replies: 2
    • Views: 3
    11-12-2016, 15:33 Go to last post
  22. Trunk ports

    Model : Hardware Version : Firmware Version : ISP : I have two tplink switches, I would like to plug in the second switch to the first switch and maintain the ability to use vlan 802.1q settings for both switches. The first switch is a sg101DE the second is a sg108e. There is not...

    Started by avayredtech‎, 09-30-2016 17:32
    • Replies: 1
    • Views: 2
    10-27-2016, 02:45 Go to last post
  23. TL-SG108PE and TL-WA801ND

    Model : Hardware Version : Firmware Version : ISP : Hi,

    Started by balonik‎, 10-05-2016 19:45
    • Replies: 1
    • Views: 2
    10-08-2016, 07:04 Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 18 replies or 150 views
Hot thread with unread posts
More than 18 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Copyright 1996-2017 TP-LINK Technologies Co., Ltd. All rights reserved.